TYPE S BUSHING NCK DIE CAT 3 284 WI

• Shellholder not included
• Bushing not Included
• Hornady, RCBS and Wilson Bushing are also compatible
• Method of determining bushing size, is to measure the neck wall thickness of the cartridge cases with a ball type or tubing micrometer. Double this measurement and add the bullet diameter to calculate the neck diameter of a loaded cartridge. As above, subtract 0.001″ from this figure to determine bushing size.

Full length resizing while maintaining exact control of the case neck is often desirable in one operation. The Type S – Full Length Resizing/Bushing Die accomplishes this task with the precision you would expect from Redding.  It uses the same interchangeable bushings (.001″ increments) as those used in our bushing style neck sizing dies.  The adjustable decapping rod allows you to adjust the bushing position, sizing only part of the neck length when desired.  Concentricity is enhanced by the ability of the bushing to self-center on the neck of the cartridge case.  All Type S (except 17 and 20 Cal.) dies are supplied with both the standard size button and a decapping pin retainer for the advantages and versatility described under our Type S – Bushing  Style Neck Sizing Dies.  Note: By removing the bushing and all internal parts, the Type-S full bushing die may also be used as a body die.Â

All dies are supplied without bushings.